Namespace Pamoja.Radios
Classes
- LoraRadio
A LoRa radio opened on a Linux board or wired to a simulated chip.
- LoraRadioConfig
What a radio sends and listens with.
- LoraRadioWiring
Where a radio module is wired on a Linux board.
- LoraReception
How a reception ended, with the frame and its signal levels when one arrived.
- LoraSentFrame
A frame a simulated chip put on the air.
- LoraTuning
What a simulated chip is tuned to.
- RadioDutyCycle
Holds a radio silent for the off time a duty-cycle limit owes after each frame.
- SimulatedLoraChip
A simulated SX126x or SX127x, which a LoraRadio drives with no radio attached.
- Sx126x
The Semtech SX1261, SX1262, SX1268, and LLCC68 LoRa transceivers.
- Sx126xBoard
How a module wires its SX126x.
- Sx126xQuery
A command that reads data back, and how much it reads.
- Sx127x
The Semtech SX1276, SX1277, SX1278, and SX1279, and modules such as the RFM95W.
- Sx127xBoard
How a module wires its SX127x.
- Sx127xRegister
The SX127x register addresses, from Table 41 of the datasheet with the LoRa page selected.
Structs
- Sx126xPacketStatus
The signal levels a LoRa frame was received at.
- Sx126xRxBufferStatus
Where the last received payload sits in the chip's buffer.
- Sx126xStatus
A decoded status byte.
- Sx126xTxPower
An amplifier setting: the SetPaConfig bytes and the SetTxParams power.
- Sx127xHighBwOptimize
The writes of the SX127x 500 kHz sensitivity erratum.
- Sx127xModem
The LoRa modem registers of an SX127x for a link.
- Sx127xModemStatus
The live state of an SX127x LoRa modem, from RegModemStat.
- Sx127xPacketStatus
The signal levels a LoRa packet was received with.
- Sx127xSpuriousReception
The receive settings of the SX127x spurious reception erratum.
- Sx127xTxPower
The amplifier settings of an SX127x: RegPaConfig, RegPaDac, and RegOcp.
Enums
- LoraRadioFamily
Which family a radio's chip belongs to.
- LoraReceptionOutcome
How a reception ended.
- Sx126xAmplifier
Which power amplifier an SX126x chip carries.
- Sx126xChipMode
The operating mode a status byte reports.
- Sx126xCommandStatus
The outcome of the last command, as a status byte reports it.
- Sx126xDeviceErrors
The faults GetDeviceErrors reports.
- Sx126xIrq
The interrupts an SX126x raises, as GetIrqStatus reports them.
- Sx127xIrq
The LoRa interrupt flags of RegIrqFlags.
- Sx127xMode
An SX127x operating mode, the Mode bits of RegOpMode.
- Sx127xPaOutput
Which amplifier output an SX127x module wires to its antenna.