Struct PamojaOpt3001Config 

#[repr(C)]
pub struct PamojaOpt3001Config {
    pub range_number: u8,
    pub long_conversion: u8,
    pub mode: u8,
    pub overflow: u8,
    pub conversion_ready: u8,
    pub flag_high: u8,
    pub flag_low: u8,
    pub latched_window: u8,
    pub active_high: u8,
    pub mask_exponent: u8,
    pub fault_count: u8,
}

An OPT3001 configuration register, field by field.

Fields

range_number: u8

The full-scale range number, 0..=11, or 12 to set the range automatically.

long_conversion: u8

1 makes a conversion take 800 ms rather than 100 ms.

mode: u8

The mode code: 0 shutdown, 1 single shot, 2 continuous.

overflow: u8

1 when the last result overflowed its range.

conversion_ready: u8

1 when a conversion has completed since the register was last read.

flag_high: u8

1 when the result went above the high limit.

flag_low: u8

1 when the result went below the low limit.

latched_window: u8

1 latches the INT pin until the configuration register is read.

active_high: u8

1 makes the INT pin active high.

mask_exponent: u8

1 makes the limit registers carry a mantissa alone, without an exponent.

fault_count: u8

The fault-count code, 0..=3, for one, two, four, or eight faults.

Trait Implementations

impl Clone for PamojaOpt3001Config

fn clone(&self) -> PamojaOpt3001Config

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Copy for PamojaOpt3001Config

impl Debug for PamojaOpt3001Config

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Eq for PamojaOpt3001Config

impl From<Configuration> for PamojaOpt3001Config

fn from(value: Configuration) -> Self

Converts to this type from the input type.

impl From<PamojaOpt3001Config> for Configuration

fn from(value: PamojaOpt3001Config) -> Self

Converts to this type from the input type.

impl PartialEq for PamojaOpt3001Config

fn eq(&self, other: &PamojaOpt3001Config) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl StructuralPartialEq for PamojaOpt3001Config